KEEBTAPE consists of a total of 15 individual pieces, from 1u size up to covering a whole 60% PCB at once, of soft 1mm thick micro suction acrylic material that acts as a sound and vibration dampener.
Most importantly, it will give your board a better, cleaner sound without any further modifications.
Easy to apply, removable without ripping apart or staining the PCB, transparent and therefore RGB underglow compatible, hot swap compatible, millmax compatible, heat resistant up to 140°C, 1mm thick to give some bottom out protection against scratches and shorts, when removed carefully it can be reused, even washed off.
Contents:2x 1u, 1x 2u, 2x 3u, 4x 4u, 1x 5u, 1x 6u, 2x 2x3u, 1x 4x5u, 1x 15x5u
I didn't really expect that much going into it, but this made an actual insane difference. Sounds a bit louder and much deeper. Honestly I'm sold on it, I would totally buy it for all my boards.- David R.
I used it on a board specifically because it doesn't sound great on it's own. The tape dampened hollowness in the case and also made the switches itself sound a little higher pitched, unlike tape and PE foam which normally makes switches sound deeper. I think it's great and it really helps cheap and bad sounding boards.- Disastertron
Compatibility - Parts for all sizes:
DISCLAIMER: Remove KEEBTAPE very slowly and with caution from PCB! Do NOT apply onto electrostatic capacitive or similar uninterrupted and componentless flat circuit boards such as HHKB™, Realforce™, NovaTouch™, or Leopold™. Components that could overheat, such as microcontroller units, should not be covered by KEEBTAPE. The Seller or Producer of KEEBTAPE does not assume any liability arising out of the application, the removal, or the use of KEEBTAPE nor be liable for negative results or any damages to the Buyer’s products or property that may occur by proper or improper use of KEEBTAPE by any person. Application and use of this product happen at the Buyer’s own risk.